There are three LED indicators on the bottom right of the Smart Switch. Below is an explanation of what they all mean.


LED status indicator

Connected to the Internet

The Controller itself is connected to the Internet. The green LED (internet) is on. The plug is installed correctly and can be operated with the HomeWizard Lite app. The installation is complete.

Connecting to the internet 

The controller itself is already connected to the home network but is trying to connect to the Internet. The green LED (internet) is flashing. The connection to the internet is lost or the installation procedure is still in progress. If the procedure does not continue (± 5 minutes), remove the plug from the wall socket and insert it again. If the problem is still occuring, reinstall the plug.

No connection to the internet

The Controller itself is not connected to the internet. The green LED (internet) does not flash or burn solid. The plug is not installed correctly or the Wi-Fi password has been entered incorrectly. Please reinstall the plug to make it work again with the Homewizard -Lite app.



Switch on

The switch of the plug is on, the  LED (power) is solid red. The plug itself is on. The switch is turned on with the lower button or with the HomeWIzard lite -App.

Switch off

The switch of the plug is off, the LED (power) is off. This means that when a lamp is plugged into the Smart Switch, the lamp is switched off. The switch is turned on with the bottom button or with the HomeWIzard lite -App. 

Learning Mode

The controller is in learning mode and ready to be installed on the Internet. The LED (power) slowly flashes red. The Smart Switch is connecting to the Internet with the HomeWizard Lite app. This status is activated by pressing the lower button (5 sec.). If you want to end the learning mode, unplug the Smart Switch. Replace it after a few seconds.  

Direct mode

The controller is in direct mode to be installed on the Internet. The red LED (power) flashes quickly. In this status, you try to connect to the Internet using the HomeWizard Lite app by connecting your phone to the plug-in wifi. This status is activated by holding down the lower button (5 sec.). If the learning mode is already active and you want to end the direct mode, unplug the power plug. Replace it after a few seconds.